Understanding the printer menus
Use
Offset Pages
None
Between Copies
Between Jobs
Quality menu
Use
Print Resolution
300 dpi
600 dpi
1200 dpi
1200 Image Q
2400 Image Q
Pixel Boost
Off
Fonts
Horizontally
Vertically
Both directions
Toner Darkness
1–10
Enhance Fine Lines
On
Off
Gray Correction
Auto
Off
To
Offset pages at certain instances.
Notes:
•
None is the factory default setting.
•
Between Copies inserts a blank sheet between each copy of a print job if
Collate is set to "(1,2,3) (1,2,3)." If Collate is set to "(1,1,1) (2,2,2)," then a
blank page is inserted between each set of printed pages, such as after
all page 1's and after all page 2's.
•
Between Jobs sets the same offset position for the entire print job
regardless of the number of copies printed.
•
This menu appears only when a supported staple finisher is installed.
To
Specify the printed output resolution in dots per inch.
Note: 600 dpi is the factory default setting.
Enable more pixels to print in clusters for clarity, in order to enhance images
horizontally or vertically, or to enhance fonts.
Note: Off is the factory default setting.
Lighten or darken the printed output.
Notes:
•
8 is the factory default setting.
•
Selecting a smaller number can help conserve toner.
Enable a print mode preferable for files such as architectural drawings, maps,
electrical circuit diagrams, and flow charts.
Notes:
•
Off is the factory default setting.
•
To set this option using the Embedded Web Server, type the network printer
IP address in the Web browser address field.
Automatically adjust the contrast enhancement applied to images.
Note: Auto is the factory default setting.
119