Lexmark M5163dn User Manual page 118

Understanding the printer menus
Use
Paper Saver Ordering
Horizontal
Reverse Horizontal
Reverse Vertical
Vertical
Paper Saver Orientation
Auto
Landscape
Portrait
Paper Saver Border
None
Solid
Staple Job
Off
On
Run Stapler Test
Hole Punch
On
Off
Hole Punch Mode
2 holes
3 holes
4 holes
To
Specify the positioning of multiple‑page images when using Paper Saver.
Notes:
•
Horizontal is the factory default setting.
•
Positioning depends on the number of page images and whether they
are in portrait or landscape orientation.
Specify the orientation of a multiple‑page document.
Note: Auto is the factory default setting. The printer chooses between
portrait and landscape.
Print a border when using Paper Saver.
Note: None is the factory default setting.
Specify whether printed output is stapled.
Notes:
•
Off is the factory default setting.
•
This menu appears only when a supported staple finisher is installed.
Print a report that confirms that the staple finisher is functioning properly.
Note: This menu appears only when a supported staple finisher is installed.
Specify whether holes will be created on printed outputs for the purpose of
collecting the sheets in a binder or folder.
Notes:
•
Off is the factory default setting.
•
This menu appears only when a supported staple, hole punch finisher is
installed.
Specify the number of holes to be created on printed outputs for the purpose
of collecting the sheets in a binder or folder.
Notes:
•
"3 holes" is the U.S. factory default setting. "4 holes" is the international
factory default setting.
•
This menu appears only when a supported staple, hole punch finisher is
installed.
118