Configuring Fips; Overview; Configuration Restrictions And Guidelines - HP FlexFabric 5700 Series Security Configuration Manual

Configuring FIPS

Overview

Federal Information Processing Standards (FIPS) was developed by the National Institute of Standard
and Technology (NIST) of the United States. FIPS specifies the requirements for cryptographic modules.
FIPS 140-2 defines four levels of security, named Level 1 to Level 4, from low to high. The device supports
Level 2.
Unless otherwise noted, in this document the term FIPS refers to FIPS 140-2.

Configuration restrictions and guidelines

When you configure FIPS, follow these restrictions and guidelines:
• After the fips mode enable command is executed, the system prompts you to choose a reboot
method. If you do not make a choice within 30 seconds, the system uses the manual reboot method.
Before you reboot the device to enter FIPS mode, the system automatically removes all key pairs
•
configured in non-FIPS mode and all FIPS-incompliant digital certificates. FIPS-incompliant digital
certificates are MD5-based certificates with the modulus length of key pairs less than 2048 bits. You
cannot log in to the device through SSH after the device enters FIPS mode. To log in to the device
in FIPS mode through SSH, first log in to the device through a console port, and then create a key
pair for the SSH server.
The password for entering the device in FIPS mode must comply with the password control policies,
•
such as password length, complexity, and aging policy. When the aging timer for a password
expires, the system prompts you to change the password. If you adjust the system time after the
device enters FIPS mode, the login password might expire before the next login, because the
original system time is typically much earlier than the actual time.
If you choose the automatic reboot method, set the system time before executing the fips mode
enable command.
If you choose the manual reboot method, set the system time before configuring the local
username and password.
• To use the manual reboot method to enter FIPS mode, you must perform the following tasks:
a. Save the current configuration file.
b. Specify the current configuration file as the startup configuration file.
c. Delete the startup configuration file in binary format.
d. Reboot the device.
Otherwise, the commands that are not supported by FIPS mode, if they are in the configuration file,
might be restored.
The system enters an intermediate state between when the fips mode enable command is executed
•
and when the system is rebooted. If you choose the manual reboot method, do not execute any
commands except for the following commands:
Reboot.
384