Connecting An External Decoder Box (2) - Pioneer DVR-433H-K Operating Instructions Manual

Connecting up
02

Connecting an external decoder box (2)

If you only have a decoder, connect it to this recorder and your TV as shown on this page.
Using the setup on this page you can:
• Record scrambled channels received using the recorder's built-in TV tuner.
Important
• Do not connect this recorder 'through' your VCR, satellite receiver or cable box. Always connect each component
directly to your TV or AV amplifier/receiver.
SCART AV
CONNECTOR
2
AC IN
Note
1 In order to use this setup, you will need to make the following settings from the Initial Setup menu:
• Set the AV2/L1 In setting to Decoder from the Initial Setup menu (see AV2/L1 In on page 94).
• From the Manual CH Setting screen, set the Decoder setting for the scrambled channels to On (see Manual CH Setting on page 93).
18
En
ANTENNA
IN
TV 1
COMPONENT VIDEO OUT
Y P
B IN
AV 2/AUTO START REC (INPUT 1/DECODER) AV 1 (RGB) – TV ANTENNA
CONTROL DIGITAL R L R L
OUT
OPTICAL
P
IN R
AUDIO VIDEO AUDIO VIDEO
S-VIDEO S-VIDEO
INPUT 3 OUTPUT
3
SCART AV
CONNECTOR
Antenna/cable TV
Decoder wall outlet
1 Connect RF antenna cables as shown.
This enables you to watch and record TV channels.
2 Use a SCART cable (not supplied) to connect the
AV1(RGB)-TV AV connector to a SCART AV connector
on your TV.
This enables you to watch discs.
3 Use another SCART cable to connect the AV2/
AUTO START REC(INPUT 1/DECODER) AV connector
ANTENNA
OUT
to a SCART AV connector on your decoder box.
This enables you to record scrambled TV channels.
OUT
ANTENNA
IN (RF IN)
1
1