Pioneer DVR-433H-K Operating Instructions Manual page 40

Recording
05
4 Use the AUDIO (SHIFT + 1) button to select the
audio channel to record.
See Changing audio channels on page 29 for more on
this.
• When recording in VR mode, if a broadcast is
bilingual, both audio channels are recorded, allowing
you to switch the audio channel on playback. The
only exception to this is when the picture quality is set
to LPCM, in which case you do need to select the
audio channel before recording.
5 Press REC to start recording.
If you want to set a recording end time, press the
button repeatedly. The recording time increases in 30
minute increments, up to a maximum of six hours. The
time the recording will end is shown on-screen and in the
front panel display. When the recording ends, the
recorder automatically switches into standby if no other
operation is being performed.
• To cancel the set recording time, press
• If you want to pause recording at any time, press
. Press again to restart the recording. (If recording
to the HDD or in VR mode, a new chapter is started
after recording restarts)
6 To stop the recording, press
• If you set the recording time in the previous step, you
can still stop the recording anytime by pressing
STOP REC.
• Recording will stop automatically when there is no
more space on the HDD/DVD, or after 12 hours of
HDD recording (whichever is sooner).
Tip
• During recording you can turn on/off the SCART loop
through function. During recording, press the front
button to switch to SCART THRU (loop
panel
through on), or
though off). Note that you can't switch loop through
on if recording from the AV2/AUTO START
REC(INPUT 1/DECODER) or AV1(RGB)-TV
connectors. Also, loop through is automatically reset
to off after recording has finished.
40
En
REC.
STOP REC.
to switch to SCART NORM (loop
Direct recording from TV
If you connected this recorder to your TV using a SCART
cable, and your TV supports Direct Recording, you can
record whatever is currently being shown on the TV
without having to worry about what channel preset the
recorder is on. Check the instructions that came with
your TV if you're not sure whether your TV supports this
feature.
REC
1 If necessary, load a recordable disc.
2 Set the picture quality/recording time using the
REC MODE (SHIFT +
3 Press TV DIRECT REC (SHIFT +
recording.
If you want to set a recording time, press the
button repeatedly. The recording time increases in 30
minute increments, up to a maximum of six hours. You
can see the recording time on-screen and in the front
panel display. When the recording ends, the recorder
automatically switches into standby if no other operation
is being performed.
• To cancel the set recording time, press
• If you want to pause recording at any time, press
. Press again to restart the recording. (If recording
to the HDD or in VR mode, a new chapter is started
after recording restarts)
4 To stop the recording, press
• If you set the recording time in step 3, you can still
stop the recording anytime by pressing
• Recording will stop automatically when there is no
more space on the HDD/DVD, or after 12 hours of
HDD recording (whichever is sooner).
Tip
• You can press TV DIRECT REC (SHIFT +
while the recorder is in standby to switch on and
immediately start recording.
• Please note that you can't record from another
component (VCR, etc.) that is connected by a SCART
cable to the AV2/AUTO START REC(INPUT 1/
DECODER) connector using the TV Direct Recording
feature.
REC MODE BACK CM SKIP
ONE TOUCH
ST0P REC
SHIFT REC
COPY
TV DRECT REC
DVD RECORDER
) button.
REC) to start
REC.
STOP REC.
STOP REC.
REC
REC)