Pioneer DVR-433H-K Operating Instructions Manual page 110

Additional information
14
Message
• There is no DV input or the input signal is unre-
cordable.
• Cannot preview because there is no DV input
or the input signal is unrecordable.
• HDD optimization is recommended. This can be
done using Disc Setup.
• Please perform HDD optimization. This can be
done using Disc Setup.
• The HDD has not been sufficiently optimized.
Please optimize again.
• This channel's TV system is different from the
recorder's setting.
• Recording failed due to a TV system mismatch.
Press DISPLAY to clear message.
• Playback has stopped because the TV system is
different than the recording.
110
En
Explanation/Action
No signal was detected at the DV IN jack. This may appear if a
blank section of DV tape is playing in the connected camcorder.
The HDD should be optimized (basically, HDD housekeeping) to
maintain playback and recording performance.
The HDD is in more urgent need of optimization in order to
maintain performance.
If this message appears repeatedly after optimizing the HDD it is
likely that there is not enough free space on the HDD for
optimization to complete properly. Please erase some titles from
the HDD and optimize again.
The TV system (PAL, NTSC, etc.) of the current channel is different
from the TV system settings of this recorder.
The timer recording failed because the TV system of the channel
set for recording was different from the setting of the recorder.
During recording or timer recording standby, the TV System (PAL,
NTSC, etc.) of the playback video changed, causing playback to
stop automatically.