Pioneer DVR-433H-K Operating Instructions Manual page 94

The Initial Setup menu
13
Setting
Component Video Out Interlace •
For Component Video Out to be effective, the AV1 Out setting (see below) must be set to something other than RGB.
AV1 Out
If you choose a setting that is incompatible with your TV you may not be able to see any picture at all. In this case either switch off and reconnect
using the supplied video cable, or reset the recorder (see Resetting the recorder on page 111).
The Component Video Out setting (see above) has no effect when AV1 Out is set to RGB.
AV2/L1 In
NTSC on PAL TV
Many recent PAL TVs are compatible with NTSC input and so this setting can be switched off. Check the operating instructions that came with
your TV. See also About NTSC on PAL TV on page 99 for related information.
Audio In Settings
Nicam Select
Tuner Level
External Audio
When the external audio is from the DV input, an audio subcode channel within the DV audio tells the recorder whether the audio is stereo or
bilingual. This has priority over the setting you make here.
94
En
Options Explanation
Select if your monitor/TV is not compatible with progressive-scan
video.
Progressive
Select if your monitor/TV is progressive-scan compatible. Check the
operating instructions that came with your monitor/TV if you're not
sure.
Video • Sets the AV1(RGB)-TV SCART output to standard composite video
(compatible with all TVs).
S-Video Sets the AV1(RGB)-TV SCART output to S-video. Recommended if you
are using a long SCART cable.
RGB Sets the AV1(RGB)-TV SCART output to RGB. Good quality but check
your TV for compatibility.
Video • Sets the AV2/AUTO START REC (INPUT 1/DECODER) SCART input to
standard composite video.
S-Video Sets the AV2/AUTO START REC (INPUT 1/DECODER) SCART input to
S-video.
RGB Sets the AV2/AUTO START REC (INPUT 1/DECODER) SCART input to
RGB.
Decoder Use this setting if you connected a decoder to the AV2/AUTO START
REC (INPUT 1/DECODER) SCART connector. For scrambled channels,
make sure that the channel Decoder setting is set to On. (See Manual
CH Setting on page 93.)
On • NTSC discs will play correctly on PAL-only TVs.
Off
Use if your TV is already NTSC-compatible.
NICAM • Record the NICAM audio in a NICAM broadcast.
Regular Audio
Record the non-NICAM audio in a NICAM broadcast. (You can still
switch the audio to record using the AUDIO (SHIFT + 1) button before
recording.)
Normal •
Standard setting.
Compression Use if the audio level from the built-in tuner is excessive, causing dis-
tortion.
Stereo • Select if the audio from the currently selected external input is stan-
dard stereo.
Bilingual Select if each channel carries a separate soundtrack.