Selecting The Hard Disk Or Dvd For Playback And Recording - Pioneer DVR-433H-K Operating Instructions Manual

Getting started
Use the buttons to move from one field to
another.
• You can go back to the previous screen at anytime in
the Setup Navigator by pressing RETURN.
7 Select the TV screen type, 'Wide (16:9)' or
'Standard (4:3)'.
Initial Setup
Basic Basic Clock Setting TV Screen Size
Tuner Input Line System
Video In/Out
Power Save
Audio In
Help
Audio Out
Setup Navigator Setup Navigator
Language
Recording
Playback
buttons to select, then press ENTER.
Use the
8 Is your TV compatible with progressive scan
video?
Initial Setup
Basic Clock Setting Progressive
Basic
Tuner Input Line System
Video In/Out Power Save
Audio In Help
Audio Out Setup Navigator Setup Navigator
Language
Recording
Playback
Use the buttons to select Compatible, Not
Compatible, or Don't Know, then press ENTER.
• Note that progressive scan video is only output
through the AV1(RGB)-TV connector and the
component video outputs.
9 Press ENTER to exit the Setup Navigator, or select
'Go Back' if you want to start again.
Initial Setup
Basic Basic Clock Setting
Set u p i s c o m p l et e!
Tuner Input Line System
Video In/Out E n j o y u si n g yo u r DV D r e co r d er !
Power Save
Audio In
Help
Audio Out
Setup Navigator Setup Navigator
Language
Recording
Playback
That completes basic setup using the Setup Navigator.
Wide (16:9)
Standard (4:3)
Compatible
Not Compatible Not Compatible
Don't Know
F in is h S e tu p
Fi n i sh S et u p
Go B ac k
Other settings you can make
After setting up using the Setup Navigator, you should be
ready to start enjoying your DVD recorder. It's possible,
however, that you may want to make a couple of
additional settings, depending on how the recorder is set
up for terrestrial TV broadcasts.
• Manual channel setting – This setting lets you skip
channels where there is no station, as well as
manually tune to stations. See Manual CH Setting on
page 93.
• If for any reason you need to cancel the setup process
before it's completed, you will be asked the next time
you switch on whether you want to start setting up
again, or whether to leave it until later.
Selecting the hard disk or DVD for
playback and recording
The HDD/DVD button (remote control and front panel) is
used to select the hard disk (HDD) or DVD for playback
and recording. The indicator in the front panel display
shows which is currently selected.
STANDBY/ON
DISPLAY TV/DVD
HELP INPUT SELECT
AUDIO SUBTITLE ANGLE
HDD/DVD
CLEAR
CHANNEL
04
27
En