Pioneer DVR-433H-K Operating Instructions Manual page 44

Recording
05
VIDEO Plus+ programming with the power
off
You can enter a PlusCode programming number when
the recorder is in standby. Note that the recording is
always made to the HDD. If you want to record to a DVD
disc, you'll need to switch on the power and use the full
VIDEO Plus+ program screen.
Important
• You can't use this feature until you have set up the
guide channels. See Set VIDEO Plus+ CH on page 93.
• You can't change the recording mode.
• You can't program daily or weekly timer recordings.
1 Press 'VIDEO Plus+ (SHIFT + MENU)'.
The front panel display shows the current recording
mode and prompts you to enter the PlusCode
programming number.
2 Use the number buttons to enter the number.
• To clear the last digit entered, press CLEAR.
3 Press ENTER.
The display shows the timer settings:
Date Start time
channel Recording mode.
• If CODE ERROR appears in the display, check that
the number is correct and that the guide channel is
set (see Set VIDEO Plus+ CH on page 93), then set
the timer recording again.
44
En
DISPLAY TV/DVD
HELP INPUT SELECT CLEAR
AUDIO SUBTITLE ANGLE
CHANNEL
VIDEO Plus+
DISC NAVIGATOR
TOP
MENU
MENU
ENTER
HOME
RETURN
MENU
REC MODE BACK CM SKIP
ONE TOUCH
ST0P REC
SHIFT REC
COPY
TV DRECT REC
End time HDD and Recording
• If CAN'T SET appears in the display, it means that
although you entered a valid number, the program
has already finished.
Setting a manual timer recording
The timer recording screen you can see all the timer
programs already set, clear programs and set up new
ones.
DISC NAVIGATOR
TOP
MENU
ENTER
HOME
MENU
REC MODE
ONE TOUCH
SHIFT
COPY
1 Press TIMER REC to display the Timer Recording
screen.
You can also access the Timer Recording screen from
the Home Menu (press HOME MENU, select Timer
Recording, then Timer Recording).
This screen shows all the timer programs currently set.
Timer Program View
SAT 26/3 15:00
Manhattan Open Tennis
SAT 26/3 18:00 – 21:00
World Journey
SUN 27/3 19:30 – 21:00
Flower
MON – FRI 13:30 – 14:00
HDD Remain
DVD Remain
• Each row is for one timer recording program, with the
date and time information, channel, recording mode,
DVD or HDD and recording status.
• The amount of free space available on the HDD and
the currently loaded recordable DVD is shown
towards the bottom of the screen.
• In the upper-right corner, the number of timer
programs already set is shown next to Tmr Pgms.
• If there are more than five timer programs already
set, press to switch page (go back using the
button).
• You can also delete a timer program before it's
started (before the recorder enters timer recording
standby) by highlighting it and pressing CLEAR. See
also Deleting a timer program on page 46.
S V
HOW IEW
MENU
RETURN
BACK CM SKIP
ST0P REC REC
TV DRECT REC
Tmr Pgms 4/32
OK
Pr 10
OK
Pr 4
Until 30/4
Pr 8
New Input
59h59m(SP)
1h59m(SP)