Emerson RTS FQ Operating Manual page 59

User Instructions
Part Number IOM – 87376-7
P10.2
P10.3
P10.4
P10.5
P10.6
P10.7
P10.8
P10.9
P10.10
P10.11
P10.12
P10.13
52
Menu Sub Menu
Item Item
Binary Output
Output Configuration
1
Binary
Output 2
Output
Binary Output 2
Output Configuration
Binary
Output 3
Output
Binary Output 3
Output Configuration
Binary
Output 4
Output
Binary Output 4
Output Configuration
Binary
Output 5
Output
Binary Output 5
Output Configuration
Binary
Output 6
Output
Binary Output 6
Output Configuration
Binary
Output 7
Output
Poss. Setting
49: Position = Position = Intermediate position 4. The width of
Int. 4 the interval is set with the parameter P8.6.
50: Position
Position = emergency position. The width of the
= Emergency
interval is set with the parameter P8.6.
Position
51: Bus Bit 1
52: Bus Bit 2
53: Bus Bit 3
54: Bus Bit 4
In existing bus interface (hardware option) the
output is set according to the selected bit bus.
55: Bus Bit 5
56: Bus Bit 6
57: Bus Bit 7
58: Bus Bit 8
Output 1 is set to normal, i.e., if the condition in
Normal point P10.1 is met, Output 1 is set to HIGH (active
HIGH).
If the condition in point P10.1 is met, Output 1 is
Inverted
set to LOW (active LOW).
Normal If the condition in point P10.1 is met, Output 1
Flashing starts blinking (active HIGH).
If the condition in point P10.1 is not met, Output
Inv. Flashing
1 starts blinking (otherwise it is set to HIGH).
See Output 1
See Output 1
Configuration
See Output 1
See Output 1
Configuration
See Output 1
See Output 1
Configuration
See Output 1
See Output 1
Configuration
See Output 1
See Output 1
Configuration
See Output 1
July 2016, Rev 1.0
Notes/Comments