Emerson RTS FQ Operating Manual page 32

User Instructions
Part Number IOM – 87376-7
Figure 25
Then, push down the selector switch until it snaps into place. In doing so, the bottom right now
on the display will show "TEACHIN" Х.
CAUTION: USE APPROPRIATE SWITCH
Once the display shows "TEACHIN", use the operating switch (black switch) to start the
motorized operation of the actuator. In this mode, no travel-dependent switch off occurs in the
end position.
CAUTION: MAX. TORQUE MUST BE PARAMETERISED
Please note that during motor operation, only torque monitoring remains active as travel
adjustment will happen subsequently. Therefore, please check beforehand whether the
maximum torque has been already parameterised.
Absolute and relative values on the display will change continuously along with position
changes.
Display (3)
July 2016, Rev 1.
25