Emerson RTS FQ Operating Manual page 47

User Instructions
Part Number IOM – 87376-7
If the value changes to 1, confirm the selection by flipping halfway up the selector switch
towards and letting it snap back to its neutral position (see
Figure 56
Figure 57
This changes the bottom line of the display from "SAVE?" to "EDIT?" and the parameter is stored.
15.3.4
Furthermore, certain parameters (end positions, intermediate positions) can be set using
"TEACHIN". Thus, their configuration is greatly simplified.
After selecting the appropriate menu item (for example: End position) and changhing the input
type from "EDIT?" to "SAVE?", move the selector switch (red) to manual mode and lock it into
place. As you do so, the display will show the message "TEACHIN" and the current position value
will be applied continuously to the parameter value. In this mode, further to manual operation
by hand wheel, the actuator can be motor-driven with the control switch to the desired position
(see Section
40
Selector Switch Flipped Halfway Up
Display (17)
"TEACHIN"
16.4.1, Figure 29).
July 2016, Rev 1.0
Figure 51 to Figure 53).