Emerson RTS FQ Operating Manual page 58

User Instructions
Part Number IOM – 87376-7
Menu Sub Menu
Item Item
Local/Remote
38: Lock Open
Ready/Torque
46: Position =
47: Position =
48: Position =
Poss. Setting
28: Binary
Forwarding of binary input to output
Input 1
29: Binary
Forwarding of binary input to output
Input 2
30: Binary
Forwarding of binary input to output
Input 3
31: Binary
Forwarding of binary input to output
Input 4
32: Binary
Forwarding of binary input to output
Input 5
As Torque OPEN although it will supress (mask)
33: Torque
this signal in the end position upon torque-
Open mask
dependent switch off.
As Torque CLOSED although it will supress (mask)
34: Torque
this signal in the end position upon torque-
Closed mask
dependent switch off.
35:Ready
Ready and Remote operating mode
Remote
36: Ready
Ready and Local operating mode
Local
37: Ready
Ready and Local or Remote mode
Lock OPEN is enabled. OPEN command is
internally queued with the highest priority and will
not be dropped even in the end position.
Lock CLOSED is enabled. CLOSED command is
39: Lock
internally queued with the highest priority and will
Closed
not be dropped even in the end position.
40: Fail-safe
Fail-safe OK (only for fail-safe actuators)
OK 1
41: Fail-safe
Fail-safe OK and Ready (only for fail-safe actuators)
OK 2
42: Fail-safe Fail-safe OK, Ready and Remote (only for fail-safe
OK 3 actuators)
43: Lock Lock Open or Lock Closed is enabled.
44:
Actuator is ready and no torque switch off
OK
45:
Ready/ Actuator is ready for operation in REMOTE mode
Remote/ and no torque switch off
Torque OK
Position = Intermediate position 1. The width of
Int. 1 the interval is set with the parameter P8.6.
Position = Intermediate position 2. The width of
Int. 2 the interval is set with the parameter P8.6.
Position = Intermediate position 3. The width of
Int. 3 the interval is set with the parameter P8.6.
July 2016, Rev 1.
Notes/Comments
51