Emerson RTS FQ Operating Manual page 42

User Instructions
Part Number IOM – 87376-7
Depending on the selector switch position, the control switch performs different functions:
Table 6.
Selector switch in the
Selector switch in the
REMOTE position
Selector switch in the
LOCAL position
15.3.2
In principle, all parameters are shown as numbers in the corresponding parameter point. From
the actuator menu, use the control switch to access different menu points. The lower left
corner of the display shows the "EDIT?" option.
Figure 44
Confirm the selector switch with a slight flip towards
the selected parameter. To confirm this input readiness, the display changes from "EDIT?" to
"SAVE?".
Selector Switch Position Table
The control switch is used to scroll up or down the menu
according to internal symbolism. From the neutral position
towards
OFF position: Towards the
the selection switch either confirms
The control switch gives you access to status, history data and
:
With the control switch, the actuator can be operated by
motor. You may also operate the actuator in inching and
self-hold mode. Switches are spring-loaded to snap back
: automatically into their neutral position. (To confirm a control
command, the control switch must be pushed all the way into
Configuration
Display (11)
you reach the status and history data areas.
symbols you reach the parameter menu. Here,
current input according to associated symbolism.
parameter area.
its mechanical locking position.)
, (see
July 2016, Rev 1.
or rejects the
Figure 33 to Figure 35) to change
35