Emerson RTS FQ Operating Manual page 41

User Instructions
Part Number IOM – 87376-7
Figure 42
Figure 43
15.3.1
Use the selector switch (red) to determine the various operating states of the actuator. In each
of these positions, it is possible to block the switch by means of a padlock and thus protect the
actuator against unauthorized access.
The selector switch has the following positions:
Table 5.
Besides defining the operational status, the selector switch is used in configuration mode to
confirm or cancel parameter inputs.
34
Halfway Switch Flip (it will jump to the next parameter category)
Full Switch Flip (it will jump to the end of the menu)
Operation Mode
Operating Mode Table
The actuator can be neither operated via the remote
OFF
control nor via the control switches of the controller.
It is possible to operate the actuator by motor via the control
switch. Control via the remote inputs may be possible with
Local
appropriate configuration (superimposed control commands,
emergency commands).
The actuator is ready to process control commands via input
Remote signals. The control switch for the motor operation of the
actuator is not enabled.
July 2016, Rev 1.0