Network Connecting; Connection Instruction; Visit Instruction - Wansview NC543 User Manual

http://www.wansview.com
specification.
2） RJ45 Ethernet Socket: RJ45 Ethernet socket is 10/100M self-adjust. The
equipment can connect to all kinds of network equipments, such as hub, router,
switch, etc.
NOTE: Factory setting IP is 192.168.0.178, the http port is 80, the username is
admin, the password is 123456.
3） RESET Button: Press it and hold on more than 10 seconds, the equipment will
restart and recover to the factory default settings.

4 Network Connecting

4.1 Connection Instruction

Before visit the IP Camera, you should firstly connect it to the Network, supply the power
to it, and check if the light of RJ45 Socket is normal to make sure all of the
communication links are fluent. The connection method is like as Figure 3.
1) IP Camera-1 and IP Camera-2 are connected separately to 2 different LANs.
2) And these 2 LANs are already connected to the Internet. In order to get the LANs to
be connected to the Internet, they are required to be equipped with router and to
apply for the communication link from the local Internet Service Provider (ISP) and
connect to it by ADSL or optical fiber, etc.
3) PC-3 is connected to the Internet.

4.2 Visit Instruction

To visit the IP Camera, you should do some settings of IP Camera and Internet besides
Figure 3
6