Wi-Fi Set Up; Wi-Fi Set Up Via Network Cable; Wps/Qss One Key Wi-Fi Set Up; Wi-Fi Set Up Via Advanced Settings - Wansview W1 User Manual

2.2 Wi-Fi Set Up

2.2.1 Wi-Fi Set Up Via Network Cable

Connect the IP camera and router via a network cable as shown in Figure 2.1.2. Log into the camera and access the system
configuration page following the steps in section 5. Web Access. Complete the set up and unplug the network cable referring to
section 5.3.2.3 to connect the camera via Wi-Fi.

2.2.2 WPS/QSS One Key Wi-Fi Set Up

Since the camera supports WPS/QSS function, Wi-Fi connection set up can be done in a simple way:
1) Please confirm whether the wireless router that the camera will be connected to supports WPS/QSS function (by reviewing the
router manual or getting support from the manufacturer of the router);
2) Connect to the power supply of the camera, and wait for 1 minute. After the camera starts-up, hold the "WPS" button of the
camera for 3s. Then click the "WPS/QSS" button of the Router. The camera and router will perform Wi-Fi configuration based on
the WPS/QSS protocol. (It may need to wait for 1-2 minutes. If not succeed, please enter to your router to check whether the
WPS/QSS function).
Attention: The configuration method is not applicable to some routers since they do not support WPS/QSS.

2.2.3 Wi-Fi Set Up Via Advanced Settings

1) Please keep the camera on-line. Click the icon on the right side of the camera.
2) Enter advanced Settings
3) Select Wi-Fi Setting
4) Automatically search for available Wi-Fi SSID
5) Select WiFi hot spots to connect to
6) Input the password
7) Click Done to complete WiFi set up.
Support Email/ Skype: service2@wansview.com 10