Visit Ip Camera From Wan; Port Forwarding - Wansview NC543 User Manual

http://www.wansview.com
and snapshot. Click button to choose the functions.
5） PTZ and video control
If device has the Pan/Tilt, in Pan/Tilt control area, user can control the position according
to the arrow sign: up, down, left, right, middle, horizontal cruise, vertical cruise, and stop
etc.
Means open IO output and Close IO output.
User can also set the device resolution, brightness, contrast and other parameters.

6 Visit IP Camera from WAN

6.1 Port forwarding

Follow the "Visit IP Camera from LAN" steps; make sure PC-1 can visit IP Camera-1. In
Figure 3, before the computers in WAN (PC-2, PC-3) can visit the IP Camera-1, must put
the IP Camera -1 into WAN. You can set port forwarding on Router-1 to put IP Camera-1
into WAN.
Open the Router Setting interface on PC-1. The interfaces for different routers are
different, and the port forwarding settings are different, please refer the router manual to
set. For most routers, "Virtual server" option can be found in setting interface. Fill the IP
address and port of IP Camera-1 into corresponding blank. Figure 8 is an example.
Select "status" option and remember the WAN IP address, enter the IP address in
browser of PC-1, if IP Camra-1 can be visited via PC-1, the port forwarding is success.
And PC-2 and PC-3 can also visit the IP Camera-1.
WAN IP address is allotted by ISP, please make sure it's an available WAN IP
address. As WAN IP address is lack, many WAN IP address are available in
limited area. If PC-2 and PC-3 are not in this area, the IP Camera-1 won't be
These buttons mean start video, stop, monitor, talk, record
Figure 8
11