Cisco Asr 1002 Router Console Port Signals And Pinouts - Cisco ASR 1001-X Hardware Installation Manual

Cisco ASR 1002 Router Console Port Signals and Pinouts

The Cisco ASR 1002 Router has RJ-45 port for the 10/100/1000 Ethernet connections. The RJ-45 port supports
IEEE 802.3ab (Gigabit Ethernet) and IEEE 802.3u (Fast Ethernet) interfaces compliant with 10BASET,
100BASETX, and 1000BASET specifications.
The RJ-45 port supports standard straight-through and crossover Category 5 UTP cables with RJ-45 connectors.
Cisco does not supply Category 5 UTP cables; these cables are available commercially.
Table 40: Management Ethernet 10/100/1000 RJ-45 Port Pinouts for Cisco ASR 1002 Router
Pin
1
2
3
4, 5
6
7,8
Cisco ASR 1002 Router Console Port Signals and Pinouts
Note Unless stated otherwise, the specifications for the Cisco ASR 1002-X Router are the same as the Cisco
ASR 1002 Router specifications listed in this section.
The following table lists the pinout of the dual RJ-45 ports for the front panel console and auxiliary ports.
Table 41: Console Port Pinouts for Cisco ASR 1002 Router
Pin
1
2
3
4
5
6
Cisco ASR 1001-X Router Hardware Installation Guide
130
Signal Direction
TX Data+ Output
TX Data– Output
RX Data+ Input
NC —
Input
RX Data–
NC —
Signal Direction
RTS Output
DTR Output
TXD Output
GND —
GND —
RXD Input
Cisco ASR 1001-X Router Specifications
Description
Transmit Data
Transmit Data
Receive Data
—
Receive Data
—
Description
Request to Send (tied to
CTS)
Data Terminal Ready
(always On)
Transmit Data
Ring Indicator
—
Receive Data