Removing And Replacing A Nim On The Cisco Asr 1001-X Router - Cisco ASR 1001-X Hardware Installation Manual

Removing and Replacing FRUs from the Cisco ASR 1001-X Router
DETAILED STEPS
Step 1 To insert a SPA, locate the guide rails that hold the SPA in place. They are at the top left and top right of the SPA slot
and are recessed about an inch.
Step 2 Carefully slide the SPA all the way in using both hands until the SPA is firmly seated in the SPA interface connector.
When fully seated, the SPA might be slightly behind the faceplate.
Step 3 After the SPA is properly seated, fasten the SPA in place with the captive installation screws on either side of the SPA.
Ensure that you fasten the captive installation screws to provide appropriate connectivity.
Note
Step 4 Restart the SPA using the following steps:
a) At the router# prompt, enter hw-module subslot 0/1 start and press Enter.
b) At the router# prompt, enter end and press Enter.
Step 5 Use the show platform command to verify whether the status of subslot 0/1 is OK.
show platform Command
Example:
Router# show platform
Chassis type: ASR1001-X
Slot Type
--------- ------------------- --------------------- -----------------
0 ASR1001-X
0/0 BUILT-IN-2T+6X1GE
0/1 SPA-4XT-SERIAL
0/2 NIM-SSD
R0 ASR1001-X
R0/0
R0/1
F0 ASR1001-X
P0 ASR1001X-PWR-AC
P1 ASR1001X-PWR-AC
P2 ASR1001-X-FANTRAY
Slot CPLD Version
--------- ------------------- ---------------------------------------
0 14041015
R0 14041015
F0 14041015
You have completed the Cisco ASR 1001-X Router SPA replacement procedure.

Removing and Replacing a NIM on the Cisco ASR 1001-X Router

The OIR feature allows you to install and replace a NIM while the router is operating. You do not have to
shut down the system's power although you should not run traffic through the NIM while it is being removed.
OIR is a method that is seamless to end users on the network, and maintains all routing information and
preserves sessions.
Note As you disengage the NIM from the router, OIR shuts down all the active interfaces in the NIM.
We recommend that you have the following tools and parts readily available for installing a NIM:

Removing and Replacing a NIM on the Cisco ASR 1001-X Router

State Insert time (ago)
ok 00:34:05
ok 00:33:14
ok 00:33:14
ok 00:33:11
ok 00:34:05
ok, active 00:34:05
ok, standby 00:32:47
ok, active 00:34:05
ps, fail 00:33:44
ok 00:33:42
ok 00:33:47
Firmware Version
15.4(2r)S
15.4(2r)S
15.4(2r)S
Cisco ASR 1001-X Router Hardware Installation Guide
111