Cisco ASR 1001-X Hardware Installation Manual page 108

Installing DC Input Power on the Cisco ASR 1001-X Router
Step 6
Use a screwdriver to tighten the terminal block captive screws, as shown in the below figure.
Figure 15: DC Power Supply with Lead Wires
1
Step 7 Repeat these steps for the remaining DC input power source wire as applicable.
Step 8 Use a tie wrap to secure the wires to the rack, so that the wires are not pulled from the terminal block by casual contact.
Step 9
Turn on the circuit breaker at the power source.
Step 10 If you have changed the Standby switch to the standby position in step 1, turn the Standby switch to the On position.
The power supply LEDs illuminate green.
What to Do Next
This completes the procedure for connecting the DC power supply in the Cisco ASR 1001-X Router.
Cisco ASR 1001-X Router Hardware Installation Guide
100
Negative (–) lead wire
Removing and Replacing FRUs from the Cisco ASR 1001-X Router
2 Positive (+) lead wire