Console Port Signals And Pinouts - Cisco ASR 901 10G Series Hardware Installation Manual

Appendix B Cable Specifications
Figure B-3
Figure B-3
1
We recommend using a shielded cable for RJ-48C connectors.
Note
Table B-2
for both the shielded and unsaddled cables for either T1 or E1.
for the RJ-45 connectors on the TDM interface module on the Cisco ASR 901 10G router.
Table B-2
Pin
1
2
3
4
5
6
7
8

Console Port Signals and Pinouts

The Cisco ASR 901 10G router ships with a console cable kit, which contains the cable and adapters to
connect a console terminal (an ASCII terminal or PC running terminal emulation software). The console
cable kit includes the following items:
•
•
•
To connect a modem, you need to order an auxiliary cable.
For console connections, see the
OL-28105-02
shows the RJ-48C connector wiring for the T1/E1 cable.
RJ-48-to-RJ-48 T1/E1 Cable Wiring
8
shows the pinout configuration for the RJ-48C connectors on the Cisco ASR 901 10G router
T1/E1 Port Pinout for the Cisco ASR 901 10G router
Signal Name Direction
RX Tip Input
RX Ring Input
— —
TX Tip Output
TX Ring Output
— —
— —
— —
RJ-45-to-RJ-45 rollover cable
RJ-45-to-DB-9 female DTE adapter (labeled TERMINAL)
RJ-45-to-DB-25 female DTE adapter (labeled TERMINAL)
Cisco ASR 901 10G Series Aggregation Services Router Hardware Installation Guide
Description
Receive Tip
Receive Ring
Not used
Transmit Tip
Transmit Ring
Not used
Not used
Not used
"Console Port Signals and Pinouts" section on page

Console Port Signals and Pinouts

Table B-2 shows the pinout configuration
B-4.
B-3