Cisco Asr 1001-X Overall Chassis Front View - Cisco ASR 1001-X Hardware Installation Manual

Cisco ASR 1001-X Overall Chassis Front View

• Stratum 3E network clocking per GR-1244-CORE, using 1588, 10 GE, GE, SPA, or Network Interface
• Six built-in 1 GE SFP-only interfaces (do not support SFP+), and two built-in 10 GE SFP+ interfaces
• One half-height SPA bay.
• Software redundancy using Dual IOS, similar to all the other nonhardware redundant routers from the
• LED indicators for Ethernet and console status, as well as visual system state indications.
• Command-line interface (CLI), alarm, network management, logging, statistics aggregation, and on-board
• Environmental chassis management.
• 10 MB ternary content-addressable memory (TCAM).
• Up to 20 Gbps sustained forwarding data traffic through the chassis.
• One Network Interface Module (NIM) bay.
Note The NIM bay supports the T1/E1 NIMs and the Solid State Device (SSD) NIM assembly and drive.
• Field-replaceable units (FRU) with online insertion and removal (OIR).
Cisco ASR 1001-X Overall Chassis Front View
The following figure shows the front of the Cisco ASR 1001-X Router.
Figure 1: Cisco ASR 1001-X Router Front View
1
2
3
Cisco ASR 1001-X Router Hardware Installation Guide
2
Module (NIM) interfaces as timing sources.
(support only 10-GE rate) that support SyncE.
Cisco ASR 1000 Series Aggregation Services Router family.
failure logging (OBFL).
NIM slots
CON—One mini eUSB
por
PWR—Power LED
Cisco ASR 1001-X Router Overview
7 Shared port adapter slot
8 USB port 0
9 USB port 1