Cisco ASR 1001-X Hardware Installation Manual page 59

Cisco ASR 1001-X Router Power Up and Initial Configuration
Example:
Router> enable
Password: <password>
Router# setup
--- System Configuration Dialog ---
Continue with configuration dialog? [yes/no]:
The prompts in the setup command facility vary depending on your router model, on the installed interface modules,
and on the software image. The following steps and the user entries (in bold) are shown as examples only.
Step 2 To proceed using the setup command facility, enter yes.
Example:
Continue with configuration dialog? [yes/no]:
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Step 3
Basic management setup configures only enough connectivity.
Example:
Would you like to enter basic management setup? [yes/no]: yes
Step 4
Enter a hostname for the router (this example uses myrouter):
Example:
Configuring global parameters:
Enter host name [Router]: myrouter
Step 5
Enter an enable secret password. This password is encrypted (for more security) and cannot be seen when viewing the
configuration.
Example:
The enable secret is a password used to protect access to
privileged EXEC and configuration modes. This password, after
entered, becomes encrypted in the configuration.
Enter enable secret: cisco
Step 6 Enter an enable password that is different from the enable secret password. This password is not encrypted (and is less
secure) and can be seen when viewing the configuration.
Example:
The enable password is used when you do not specify an
enable secret password, with some older software versions, and
some boot images.
Enter enable password: cisco123
Step 7
Enter the virtual terminal password, which prevents unauthenticated access to the router through ports other than the
console port:
Example:
The virtual terminal password is used to protect
Using the Cisco setup Command Facility
Cisco ASR 1001-X Router Hardware Installation Guide
51