Safety Warnings - Cisco ASR 1001-X Hardware Installation Manual

Preparing Your Site for Installation
Danger This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that the
protective device is rated not greater than: AC power supply for the Cisco ASR 1001-X Router: 120 VAC,
30A U.S. maximum. DC power supply for the Cisco ASR 1001-X Router: 30A U.S. maximum. Statement
1005
This product requires short-circuit (overcurrent) protection to be provided as part of the building installation.
Danger
Install only in accordance with national and local wiring regulations. Statement 1045
This unit may have more than one power supply connection. All connections must be removed to
Danger
de-energize the unit. Statement 1028
This unit is intended for installation in restricted access areas. A restricted access area can be accessed
Danger
only through the use of a special tool, lock and key, or other means of security. Statement 1017
The plug-socket combination must be accessible at all times, because it serves as the main disconnecting
Danger
device. Statement 1019
Hazardous voltage or energy may be present on the DC power terminals. Always replace cover when
Danger
terminals are not in service. Be sure uninsulated conductors are not accessible when cover is in place.
Statement 1075
Use copper conductors only. Statement 1025
Danger
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
Danger
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection authority
or an electrician if you are uncertain that suitable grounding is available. Statement 1024
Hazardous voltage or energy is present on the backplane when the system is operating. Use caution when
Danger
servicing. Statement 1034
Class 1 laser product. Statement 1008
Danger
Cisco ASR 1001-X Router Hardware Installation Guide
General Safety Warnings
29