Removing Ac Power Supplies From The Cisco Asr 1001-X Router - Cisco ASR 1001-X Hardware Installation Manual

Removing AC Power Supplies from the Cisco ASR 1001-X Router

When you install the unit, the ground connection must always be made first and disconnected last. Statement
Danger
1046
Before performing any of the following procedures, ensure that power is removed from the DC circuit.
Danger
Statement 1003
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Danger
Statement 1030
Removing AC Power Supplies from the Cisco ASR 1001-X Router
This section describes how to remove an AC power supply from the Cisco ASR 1001-X Router. The Cisco
ASR 1001-X Router has two power supply slots, power supply slot 0 (PS0) next to the Standby switch and
power supply slot 1 (PS1) to the right, as shown in the below figures.
The Cisco ASR 1001-X Router has redundant power supplies that can be hot-swapped.
Note
Follow these steps to remove an AC power supply from the Cisco ASR 1001-X Router:
SUMMARY STEPS
1. At the rear of the router, ensure that the power switch is in the Standby position.
2. Unplug the power cable from the power supply as shown in the below figure.
3. Press the retaining latch towards the pull handle, grasp the handle with one hand, and pull the power supply
out of the slot while supporting the weight of the power supply with the other hand, as shown in the below
figure.
4. Repeat these steps if it is required to remove the other AC power supply.
DETAILED STEPS
Step 1 At the rear of the router, ensure that the power switch is in the Standby position.
It is not required to place the power switch in the Standby position if you want to hot-swap a single power
Note
supply.
Cisco ASR 1001-X Router Hardware Installation Guide
92
Removing and Replacing FRUs from the Cisco ASR 1001-X Router