Cisco ASR 1001-X Hardware Installation Manual page 103

Removing and Replacing FRUs from the Cisco ASR 1001-X Router
It is not required to place the power switch in the Standby position if you want to hot-swap a single power
Note
supply.
Figure 11: Cisco ASR 1001-X Router AC Power Supply Standby Switch
1
Step 2 Insert the power supply module into the appropriate slot(s), making sure that the retention latch is firmly placed. You
can verify that the power supply module is firmly latched by gently pulling the power supply handle.
Step 3 Insert the power supply cables firmly into the power supplies.
Ensure that both power supplies are inserted firmly and the power cords are in place.
Note
Installing AC Power Supplies in the Cisco ASR 1001-X Router
Cisco ASR 1001-X Router Standby switch, which does
not disconnect power from the power source.
Cisco ASR 1001-X Router Hardware Installation Guide
95