Error Messages - NTT docomo F-05J arrows Be Instruction Manual

■ Bluetooth
● The terminal cannot be connected to a Bluetooth device/
A Bluetooth communication device cannot be found
from the terminal.
Make Bluetooth device (commercially available)
detectable and then register the device on the terminal. If
you delete already registered device and register the
device again as a new device, delete the registrations on
both the terminal and Bluetooth device (commercially
available), and then perform registration of the devices.
● Calls cannot be made from the terminal connected to an
external device such as car navigation or handsfree
device.
If calls are made several times when the other party does
not answer or is out of service, the call to this number
may be disabled. In this case, turn the terminal OFF and
ON.
■ Maps/GPS function
● Cannot set AUTO-GPS service information.
•
Is AUTO-GPS function disabled due to battery low? If
AUTO-GPS is disabled by Lower-power operation
settings, AUTO-GPS service information cannot be set.
In this case, set Lower-power operation settings to [Not
suspend] or charge the battery.→P35 , P142
•
Mark [AUTO-GPS] operation settings.→P142
•
Is the GPS function OFF? When the GPS function is OFF,
AUTOGPS function stops.→P114
■ Others
● Data saved in USB mass storage is not displayed.
Reattach the USB mass storage.

◆ Error messages

● Memory space is full
The terminal is low on memory. If you keep using, some
functions and applications may not be operated.
Open setting screen to select unnecessary apps, then
press "Uninstall" to uninstall them.
Displayed when available memory of the terminal is low.
Tap [Setting screen] to delete unnecessary applications.
Alternatively, end running applications or clear cache of
applications to increase memory space.→P56, P138
● All voice services are blocked./Voice service is blocked./
Emergency service is blocked./Data service is blocked.
Phone line or packet communication facilities are broken
down or line or packet communication network is very
busy. Wait a while and then operate again.
● PUK is locked.
If you enter a wrong PUK code of the docomo nano UIM
card 10 times consecutively, this message is displayed.
Contact a sales outlet such as docomo Shop.→P145
● No SIM card.
Check if the docomo nano UIM card is installed to the
terminal correctly.→P31
● SIM card is locked.
Displayed when you turn on the terminal with PIN code
enabled. Enter the correct PIN code.→P152
● SIM card is PUK-locked.
Displayed when the docomo nano UIM card is locked by
PUK. Unlock with correct PUK code.→P152
183
Appendix/Index