NTT docomo F-05J arrows Be Instruction Manual page 34

■ Installing
a Face down the display side of the terminal and open the
slot cap hooking the groove with your fingertip (a)
b Put your fingertip on the groove of the tray and pull it
straight out (b)
･
The tray is designed to be removed from the docomo
nano UIM card slot.
c With the IC side facing up, place the docomo nano UIM
card on the tray (c)
･
Check the orientation of docomo nano UIM card corner
cut.
d Make sure that the display side of the terminal is facing
down, then insert the tray straight into the docomo nano
UIM card slot (d)
c
d
e Press firmly the slot cap of the terminal to close→P25
Corner cut
IC
Tray
b
Groove
Slot cap
■ Removing
a Face down the display side of the terminal and open the
slot cap hooking the groove with your fingertip
b Put your fingertip on the groove of the tray, pull it straight
out, then remove the docomo nano UIM card
c Make sure that the display side of the terminal is facing
down, then insert the tray straight into the docomo nano
UIM card slot
d Press firmly the slot cap of the terminal to close→P25
✔INFORMATION
･
When handling docomo nano UIM card, take care not to
touch or scratch the IC. Also, be aware that trying to insert or
remove the docomo nano UIM card using excessive force
may cause it to break.
･
For removing/inserting the tray from/into the docomo nano
UIM card slot, do not remove or insert forcibly. Doing so may
damage the tray.
･
IMEI sheet with IMEI number and bar code printed is inserted
under the docomo nano UIM card slot. Do not pull out the
IMEI plate because it will be requested at a DOCOMO-
specified repair office when the terminal is damaged etc.
Also, please note the following.
- If you pull out the IMEI sheet accidentally, insert it.
a
- Do not pull out the IMEI sheet forcibly because it may cause
damage.
- If you lost the IMEI sheet, repairs may be refused.
32
Before using the terminal