Table of Contents
Advertisement
Bluetooth function
■
The terminal cannot be connected to a
Bluetooth communication device/A
Bluetooth communication device cannot
be found from the terminal.
Make Bluetooth communication device
･
(commercial item) registering stand-by
state and then register the device on the
terminal. If you delete already registered
device and register the device again as a
new device, delete the registrations on
both Bluetooth communication device
(commercial item) and the terminal and
then perform registration of the devices.
P.168
→
Calls cannot be made from the terminal
connecting to external device such as car
navigation or handsfree device.
If calls are made several times when the
･
other party does not answer or is out of
service, the call to this number may be
disabled. In this case, turn terminal off and
on.
Map/GPS
■
Cannot set AUTO-GPS service
information.
Check if the battery level is low and AUTO-
･
GPS function is stopped.
If AUTO-GPS is stopped by "Lower-power
operation settings", AUTO-GPS service
information cannot be set. In this case, set
"Lower-power operation settings" to "Not
suspend" or charge the battery.
P.148
Check if "AUTO-GPS operation settings" is
･
marked.
P.148
→
Error messages
No service
●
The terminal is out of service area, or the
･
received signal is too weak. Move to a
location where radio signal can be
reached.
The docomo mini UIM card is not working
･
properly.
Insert the docomo mini UIM card in
another terminal. If this works, it is
probably the terminal that is causing the
problem. In this case, contact "Repairs" on
the last page of this manual (in Japanese
only).
Removing and inserting docomo mini
UIM card may improve the problem.
P.35,
→
Appendix/Index
256
Advertisement
Table of Contents
