Av Compu Link Remote Control System - JVC RX-9010VBK Service Manual

AV COMPU LINK Remote Control System

This receiver is equipped with the AV COMPU LINK-III. The AV COMPU LINK remote control system allows you to
operate JVC video components (TV, VCR, and DVD player) through the receiver. To use this remote control system, you
need to connect the video components you want to operate, following the procedure below.
1. If you have already plugged your VCR 1 (VCR connected to the VCR 1 jacks), DVD player, TV, and this
receiver into the AC outlets, unplug their AC power cords first.
2. Connect the IR signal transmitter (supplied) to the IR OUT on the rear, and place it so that it is aimed at
the remote sensor on the target video components.
• See "CONNECTIONS 1" below.
3. Connect your VCR 1, DVD player, TV, and this receiver as follows, using the cables with the monaural
mini-plugs (not supplied).
• See "CONNECTIONS 2" below.
4. Connect the audio input/output jacks on VCR 1, DVD player, TV, and this receiver using the cables with
RCA pin plug.
• See pages 8 and 9.
5. Connect the video input/output jacks on VCR 1, DVD player, TV, and this receiver, using the cables with
RCA pin plugs, with S-video plugs or with component video plugs.
• See "CONNECTIONS 3" on the next page.
6. Plug the AC power cords of the components into the AC outlets.
7. When turning on the TV for the first time after the AV COMPU LINK connection, turn the TV volume to
the minimum using the TV volume control on the TV.
8. Turn on the other connected components first, then turn on this receiver.
• When turning on the VCR 1, use the remote control supplied with this receiver (press VCR 1 POWER).
CONNECTIONS 1: IR Signal Transmitter Connection
On the rear panel
CONNECTIONS 2: AV COMP LINK Connection
VCR 1
VHS
AV
COMPU LINK
Notes:
• The AV COMPU LINK remote control system cannot control the DBS tuner connected to the TV SOUND/DBS and DBS component video
terminals, and video components connected to the VIDEO and VCR 2 terminals on the receiver.
• When connecting only the VCR 1 and DVD player to this receiver, connect it directly to the receiver using cable with the monaural mini-
plugs.
• When connecting the receiver and the TV with AV COMPU LINK EX terminal by using the component video cables, you cannot use
Automatic Selection of TV's Input Mode (see page 64).
• Refer also to the manual supplied with your video components.
RF REMOTE
ANTENNA
IR OUT
DVD player
DVD
AV
COMPU LINK
RX-9010VBK
Target video component(s)
At an angle of
approx. 60°
IR signal transmitter
TV
AV
COMPU LINK EX
AV
COMPU LINK III
CAUTION:
You can only connect the TV with
AV COMPU LINK to the AV
COMPU LINK EX or AV COMPU
LINK III terminal.
DO NOT connect the TV with AV
COMPU LINK to the AV COMPU
LINK RECEIVER/AMP terminal.
62