Activating The Sub-Room Front Speakers; Muting The Sub-Room Sound; Operating The Playback Source For The Sub-Room - JVC RX-9010VBK Service Manual

Activating the Sub-room Front Speakers

This section is not for the persons who connect the sub-room
front speakers to the SUB ROOM PRE OUT jacks using
another amplifier (see page 14).
Before you start, remember...
• When shipped from the factory, both pairs of the front speakers
have been set to be used in the main room. To use the front
speakers connected to the FRONT 2/SUB ROOM SPEAKERS
terminals for the sub-room, see "Setting the Front Speakers Either
for the Main Room or Sub-room" on page 27.
On the front panel ONLY:
Press SPEAKERS ON/OFF SUB ROOM to activate
the front speakers in the sub-room.
The SPEAKERS SUB ROOM indicator lights
up on the display.
• Each time you press the button, the lamp on
the button turns on and off.
To deactivate the front speakers in the sub-
room, press
SPEAKERS ON/OFF SUB ROOM again.
Note:
If the center speaker or rear speakers are used for the Surround/DSP
mode (see page 37) for the main room operations,
the SPEAKERS ON/OFF SUB ROOM button does not work.

Muting the Sub-room Sound

From the remote control ONLY:
Press MUTING to mute the sound
through the front speaker in the sub-
room.
The volume level indicator goes off.
To restore the sound, press MUTING again so that the volume
level indicator appears on the display.
• Turning MASTER VOLUME on the front panel or pressing
VOLUME +/– on the remote control also restores the sound.
Operating the Playback Source for the
Sub-room
• When you select "FM" or "AM" as the sub-room source, you can
do the following:
– Tune into any station frequency manually (see page 35).
On the front panel
– Select a preset station (see pages 35 and 36).
1
2
On the front panel
– Select FM reception mode (see page 36).
On the front panel
• When you select the other sources as the sub-room source, you
can operate them by using the remote control supplied with this
MUTING
receiver. ("TV SOUND," "DVD MULTI" and the digital input
cannot be selected as the sub-room source.)
– If they are one of the JVC products equipped with the COMPU
LINK remote control system or the AV COMPU LINK remote
control system, see pages 55 to 64.
– If they are one of the JVC products, but not equipped with the
above remote control systems, or if they are the products of the
other manufacturers, see pages 65 to 71.
CAUTION:
Be careful not to turn up the volume so high when controlling the
receiver without listening to the playback sound. For example, when
adjusting the volume level in the sub-room from the main room.
Notes:
• Any sound adjustments such as the Surround/DSP modes cannot
be applied to the sub-room source. You can only adjust the volume
level.
• The One Touch Operation function (see page 34) cannot be used
for the sub-room sources.
/REW
FM/AM TUNING
DOWN
From the remote control
L—BALANCE—R
1
CENTER
FM/AM PRESET
4
REAR·L
7
/P
DIGITAL EQ
10
RETURN
From the remote control
FM MODE
From the remote control
PLAY
FF/
TUNING UP
EFFECT
2 3
SUBWFR ROOM SIZE
5 6
REAR·R LIVENESS
8 9
CENTER TONE
0 + 10
100 +
FM MODE
0
FM MODE
26