Compu Link Remote Control System - JVC RX-9010VBK Service Manual

COMPU LINK Remote Control System

The COMPU LINK remote control system allows you to operate JVC audio components through this receiver.
To use this remote control system, you need to connect JVC audio
components through the COMPU LINK (SYNCHRO) jacks (see
below) in addition to the connections using cables with RCA pin
plugs (see pages 7 and 8).
• Make sure that the AC power cords of these components are
unplugged before connection. Plug the AC power cords only after
all connections are complete.
CD player
CD recorder
Cassette deck
or
MD recorder
RX-9010VBK
Turntable
IMPORTANT:
Check to see if the proper indicator(s) and information appear on the
display on the front panel before/while using the buttons and controls.
When using the buttons and controls on the front panel:
• For the main room operations
– The MAIN ROOM indicator is lit.
– The source name for the sub-room is not lit on
the display.
• For the sub-room operations
– The SUB ROOM indicator is lit.
– The source name for the sub-room is lit on the
display.
When using the remote control:
• For the main room operations
– Set MAIN ROOM/SUB ROOM selector to
"MAIN ROOM."
• For the sub-room operations
– Set MAIN ROOM/SUB ROOM selector to "SUB ROOM."
55
Notes:
• There are four versions of COMPU LINK remote control system.
This receiver is equipped with the fourth version — COMPU LINK-
4. This version is created by adding systematic operations with the
CD recorder to the previous version — COMPU LINK-3.
• If your audio component has two COMPU LINK jacks, you can use
either one. If it has only one COMPU LINK jack, connect it so that it
is the last item in the series of components. (For example, the
turntable or CD player in the diagram above.)
• To operate the cassette deck or MD recorder using the COMPU
LINK remote control system, set the source name correctly. (See
page 33.)
• Refer also to the manuals supplied with your audio components.
This remote control system allows you to use four functions listed
below.
Remote Control through the Remote Sensor on the
Receiver
You can control the connected audio components through the
receiver using this remote control. For details, see pages 65 – 67.
Automatic Source Selection
• When you press the play (3 3 3 3 3 ) button on a connected component or
on its own remote control, the receiver automatically turns on and
changes the main room source to the component.
COMPU LINK – 4
ANALOG
(SYNCHRO)
– If the receiver is already turned on, and the SUB ROOM
indicator and the source name for the sub-room are lit on the
display, the receiver changes the sub-room source to the
component.
• When you press PLAY on the remote control
supplied for this receiver, the receiver
automatically turns on and changes the main
room source or sub-room source (depending on
MAIN ROOM/SUB ROOM selector setting on the remote control)
to the target component.
• When you select a new source on the receiver or on the remote
control supplied for this receiver either for the main room or sub-
room, the newly selected component begins playing immediately,
and the previously selected source continues playing without
sound for a few seconds.
MAIN ROOM SUB ROOM
L R
SPEAKERS
1
SPEAKERS
SUB ROOM
MAIN ROOM
VOLUME
SUB ROOM
VOLUME
PLAY