Fault Tracing; Internal Fault Indications - ABB RET670 Commissioning Manual

Section 15
Troubleshooting
15.2
15.2.1
304
Indicated result Possible reason
Real time clock Ready No problem detected.
Real time clock Fail The real time clock has
been reset.
ADC-module OK No problem detected.
ADC-module Fail The AD conversion
module has failed.
(Protocol name) Ready No problem detected.
(Protocol name) Fail Protocol has failed.
(I/O module name) No problem detected.
Ready
(I/O module name) Fail I/O modules has failed.

Fault tracing

Internal fault indications

If an internal fault has occurred, the local HMI displays information under Main menu/
Diagnostics/IED status/General
Under the Diagnostics menus, indications of a possible internal failure (serious fault) or
internal warning (minor problem) are listed.
Indications regarding the faulty unit are outlined in table 37.
Table 37: Self-supervision signals on the local HMI
HMI Signal Name: Status
INT Fail OFF / ON
INT Warning OFF / ON
ADMnn READY / FAIL
BIMnn READY / FAIL
Table continues on next page
Proposed action
None.
Set the clock.
None.
Contact your ABB representative for service.
None.
None.
Check that the I/O module has been configured and
connected to the IOP1- block.
If the problem persists, contact your ABB
representative for service.
Description
This signal will be active if one or more of
the following internal signals are active;
INT--LMDERROR, INT--WATCHDOG,
INT--APPERROR, INT--RTEERROR, or
any of the HW dependent signals
This signal will be active if one or more of
the following internal signals are active;
INT--RTCERROR, INT--
IEC61850ERROR, INT--
TIMESYNCHERROR
Analog input module n failed. Signal
activation will reset the IED
BIM error. Binary input module Error
status. Signal activation will reset the IED
Transformer protection RET670 2.2 ANSI
1MRK 504 165-UUS -
Commissioning manual