Table of Contents
Advertisement
§ 7
Humidity is only
available on
MODEL6531/6533.
Air temperature is
only available on
MODEL6531/6541
/6542/6533/6543/
6561.
Pressure is only
available on
MODEL6501-B0
/-C0.
34
Print Out
www.lazodecontrol.com
Print Out
Preparation for Printing
Connect the printer cable to the Serial
Communication terminal located on
the side of the instrument to print out
measurement data.
<Requirements>
Printer (optional)
DPU-S245
Printer Cable (optional)
<Check the BAUD RATE>
You need to enter the same baud rate and data transmission
conditions on both the Main Body and the printer.
The factory setting of the Main Body is as follows:
Data Bit Length
Parity
Set Value
Baud Rate
Stop Bit
<Connecting the Printer>
1. Connect the printer to the Main Body (Serial Communication
Terminal) using the printer cable.
2. Turn ON the CLIMOMASTER first, and then turn the printer ON.
3. Make sure that the CLIMOMASTER is displaying NORMAL Mode.
Print Out in NORMAL Mode
'12/04/12a15:40:23 ~
0.87f
TCC1
HOLD
25.3e
64.1g
*
If the printer is not connected properly,
the lower left of the display.
Examples of Print Out
Air Velocity Mode
2001/06/19 13:42:09
Velocity
0.12 m/s
Temperature 25.9
Humidity
62.7 %RH
+51 960 810 089
Communication
Recommended: Seiko Instruments Model
*To change the BAUD RATE, refer to
8 bits
None
*To configure the settings of the
printer, refer to the printer operation
manual.
1
When the screen is displaying in
NORMAL Mode, press
display. Press
on the screen.
2001/06/19 13:42:28
Air Velocity
Pressure
Air Temperature
C
Humidity
Serial
Terminal
46.
to HOLD the
to print out the data
Pressure Mode
0.23 kPa
ventas@lazodecontrol.com
Advertisement
Table of Contents
