Table of Contents
Advertisement
3.
Service Mode
This mode is used to check and specify service functions.
3-1.
Service mode displays
Service
FACE CONUT
CONTROLLER
VER.
ENGINE VER.
DIMM FULL TEST
SDRAM FULL
TEST
POWER ON
TEST
USER DEFAULT
3-2.
Entering the service mode
<Procedure>
1. With the menu "ENGINE" selected, press the Down key.
2. Press the Prev. key until "ENGINE SERVICE" is displayed.
3. Press both the Select and the Down keys at the same time for at least 2 seconds.
4. With "SERVICE PERSON" displayed, press the Down key.
<Cancelling procedure>
• Press the Cancel key.
3-3.
Service mode options
(1)
RESTORE FACTORY DEFAULT
• Select this option to restore all settings to their defaults.
Language, Energy Saver, Auto Continue, Chaining Tray, IP Address, Subnet Mask, Gateway, DHCP/
BOOTP, All toner max life=1500, All remaining=100%, All counters, CPU counters for service, PSL
admin password.
(2)
SERVICE PERSON SRU USAGE
• Select this option to display the remaining service life for the image transfer belt unit and
the drum unit.
(3)
RESET CONTROLLER
• Select this option to reset the controller.
(4)
RESET COUNTER FUSER UNIT
• Select this option to reset the counter for the fusing unit.
SERVICE
RESTORE FACTORY
SERVICE PERSON
DEFAULT
SERVICE PERSON
SRU USAGE
RESET CONTROLLER
RESET COUNTER
FUSER UNIT
116
Advertisement
Table of Contents
Troubleshooting
