Ld6 Safety Summary; Unpacking And Inspection; Safety Symbols; Safety Warnings - Veripos LD6 Installation Manual

Document title: LD6 Installation Manual
Document No. AB-V-MA-00520
1.5
This section summarizes safety guidelines when installing the LD6 unit.
1.5.1
Carefully unpack the unit and retain packaging to return the equipment where required.
Inspect the unit. If the equipment appears damaged return it using the original
packaging. Responsibility for damage is not accepted if the approved packaging is not
used.
Ensure all items and ancillary equipment is present. Contact your supplier or VERIPOS
where this is not the case (see contacts in the Contact information chapter).
1.5.2
Please see section 1.6 Document conventions later in this manual
1.5.3
Always observe the following safety precautions:
Rev No: L10
Date: 03.04.2017

LD6 SAFETY SUMMARY

Unpacking and inspection

Safety symbols

Safety warnings


Disconnect power from both AC and DC inlets on the rear panel to isolate
the equipment before working on it.

Never use a detachable AC/DC supply cord with inadequate rating.

If the equipment is used in a manner not specified by VERIPOS, the
protection provided by the equipment may be impaired.

Ensure adequate air circulation to ventilate the unit especially to the sides to
avoid heat build-up.

Only connect to an earthed power supply. The LD6 unit is class 1
construction and must be earthed.

Connect only to a power supply with a voltage corresponding to that marked
on the unit.

Always disconnect the LD6 and associated equipment from the mains when
connecting equipment, inserting/removing modules by removing the AC/DC
supply and ancillary connections before removing from the rack.
NOTE
There is a retention clip which, when used, prevents accidental
removal of the AC power plug.

The equipment is heavy: use handles where provided.

The equipment is for use in moderate climates only. Never use the
equipment in damp or wet conditions.

Avoid excessive heat, humidity, dust and vibration.

Do not use where the equipment may be subjected to liquids.

Always use the power connections supplied with the unit. See the Reference
information chapter for details.

Before replacing a fuse disconnect the equipment from both AC and DC
supplies.
.
Page 9
LD6 Installation Manual