Siting The Ld6 Receiver; Ventilation Requirements; Ld6 Siting Guides - Veripos LD6 Installation Manual

Document title: LD6 Installation Manual
Document No. AB-V-MA-00520
3.2
The LD6 (2U) unit is recommended to be housed in a 19" rack with suitable ventilation.
3.2.1
The unit is designed to be ventilated at the sides. Each side of the unit should have > 55
mm clearance.
3.2.2
1. Ensure adequate ventilation – above and especially to the vents for free air flow
2. Locate unit in areas free from excessive dust or smoke.
3. Avoid locations that experience excessive vibration.
4. Avoid exposure to high temperatures.
5. Shield the unit from direct sunlight.
6. Mount the unit securely to prevent movement.
7. Ensure there is easy access to front panel.
8. Ensure adequate access to the rear panel. Avoid mounting in a recess and have
9. All bends in coaxial cables to be maintained above minimum bend radius.
10. Use short tails of flexible coaxial cable (e.g. LMR 240) with appropriate converter
11. Connect the unit to a ships ground using the grounding point on the rear of the
Rev No: L10
Date: 03.04.2017

SITING THE LD6 RECEIVER

Ventilation Requirements

Figure 7. Rack mounted LD6 receiver with suitable ventilation

LD6 siting guides

to the unit.
sufficient slack to be left in cables (power, interfacing and coaxial) for LD6 unit to
be removed without disconnection.
connections to connect antenna coaxial cables to the LD6. Support the antenna
coaxial cable weight to avoid stress being placed on the rear coaxial connectors.
LD6.
Page 20
LD6 Installation Manual