Installation; Maintenance; Servicing; Fault Diagnosis - Veripos LD6 Installation Manual

Document title: LD6 Installation Manual
Document No. AB-V-MA-00520
1.5.4
Ensure the AC and/or DC power supplies are disconnected during installation. The
power connections are easily accessed on the rear of the unit (see Figure 4 in the
System Description chapter).
Ensure that the unit is secured within the rack by the supplied brackets and fittings.
Position the unit to ensure there is ample spacing for ventilation of the unit and access to
front and rear during normal operation.
Ensure all cables are routed safely to avoid sharp edges, bends and pinches.
Ensure only the specified cables are used for interconnection of the equipment.
Permanently connect the vessels' protective earth to the protective bonding connection
on the unit.
1.5.5
Clean the unit using a clean dry cloth only. Do not wet the unit or allow moisture to
penetrate the unit. Do not use solvents to clean the unit.
Fuses must only be replaced using a fuse of the type and rating as marked.
If a replacement fuse fails: immediately contact your local service agent. Do not replace
the fuse with one of a higher value.
1.5.6
This unit contains no user-serviceable parts. Please refer all repairs to a qualified
service agent or to VERIPOS. See the Reference information chapter for details.
1.5.7
Follow the guidance in this document to correctly install the LD6. Where the LD6 does
not perform as indicated please first check all connections before contacting your
supplier or VERIPOS for assistance (contact details in the Reference information
chapter).
Rev No: L10
Date: 03.04.2017

Installation

Maintenance

Servicing

Fault diagnosis

Page 10
LD6 Installation Manual