1Pps Output Option; Ethernet Interface - Veripos LD6 Installation Manual

Document title: LD6 Installation Manual
Document No. AB-V-MA-00520
LD6 Software version 101.0.0.9 & above
See the Reference information chapter for pin-out details and contact VERIPOS for
advice where required.
3.6.3
Some LD6 variants provide a facility for output of a 1PPS (one pulse per second) signal,
used by external equipment for accurate time synchronisation to navigation systems or
multi-beam sonar.
3.6.4
Two Ethernet RJ45 connectors are fitted on the LD6 rear panel. These can have static or
DHCP addresses (see table below).
Specific guidance for interconnect to vessel equipment can be provided. Contact the
VERIPOS Helpdesk for advice.
The LAN ports have default fixed IP addresses:


When attaching the LD6 directly to the PC, VERIPOS recommend that RJ45 patch
cables using the RJ45 crossover module supplied are attached to the PC LAN port,
which is assigned a fixed IP address of 192.168.2.4 (assuming LD6 LAN1 is used).
Rev No: L10
Date: 03.04.2017
COM Port Source
COM1 L-Band
COM2 GNSS
COM3 GNSS
COM4 L-Band
COM5 MF
COM6 UHF

1PPS Output Option

Ethernet Interface

192.168.2.2 (Upper port)
192.168.3.3 (Lower port)
Content Format
RTCMa RS232
NMEAa RS232
Raw RS232
RTCMb RS232
RTCM RS232
RTCM RS232
Rate (bps)
9600
9600
115200
9600
9600
9600
Page 33
LD6 Installation Manual