Antenna Installation; Antennas - Veripos LD6 Installation Manual

Document title: LD6 Installation Manual
Document No. AB-V-MA-00520
3.3
This section provides general guidance on installation of antennas and cabling when
installing the LD6 receiver.
It is very important to the ongoing performance of your system that a high quality
installation is performed. There should be no compromise on quality to ensure ongoing
correct performance.
3.3.1
The antennas for use with the LD6 are summarized below.
* The V460 and V86 (and optionally FUC/6) antennas are the models currently supplied
by VERIPOS. The other antenna models shown are some of those which may have
previously been supplied with the LD6.
Antenna Name
Rev No: L10
Date: 03.04.2017

ANTENNA INSTALLATION

Antennas

Type
GNSS Receives position signals from GNSS
satellites
L-Band (Spot) Receives VERIPOS corrections from
geostationary satellites
MF option Receives non-VERIPOS corrections from
local MF Beacon transmitters
UHF option Receives non-VERIPOS corrections from
local UHF radio transmitters
V460* AD491
Main Signal
V460* Dual Freq. GNSS (GPS,
GLONASS, Galileo,
BeiDou, QZSS)
AD491 Dual Freq. GNSS (GPS,
GLONASS)
V86*
90984
A31
FUC/6
Detail
V86* 90984
Figure 9. LD6 compatible antennas
Other Signal
L-Band, MF
L-Band
L-Band
MF L-Band & L1 GPS
UHF
LD6 Rx Card
Connection
TNC
N-type
TNC
BNC
A31
Antenna
Connection
Type
TNC
L-Band N-type
MF N-Type
- N-type
TNC
- N-type
LD6 Installation Manual
FUC/6*
Page 22