Wall Mounting Template - Motorola SURFboard SVG1501 Series User Manual

There must be .10 inches (2.5 mm) between the wall and the underside of the screw
head.
7. Place the SVG1501 so the keyholes on the back of the unit are aligned above the
mounting screws.
8. Slide the SVG1501 down until it stops against the top of the keyhole opening.
After mounting, reconnect the coaxial cable input and Ethernet connection. Plug the
power cord into the +12VDC connector on the cable modem and the electrical outlet.
Route the cables so that they are not a safety problem.

Wall Mounting Template

You can print the following page to use as a wall mounting template.
Be sure you print it at 100% scale. In the Print dialogue window, be sure that Scale to
paper size is set to No scaling in the Print dialog box.
Measure the printed template with a ruler to ensure that it is the correct size.
2 • Getting Started
This document is uncontrolled pending incorporation in a Motorola CMS
6.0 mm (.24 inches) maximum
9.0 mm (.35 inches) maximum
2.5 mm (.10 inches).
23