Download Print this page

Getting Started; Before You Begin - Motorola SURFboard SVG1501 Series User Manual

Wireless voice
Hide thumbs


Table of Contents
This section provides information on setting up and installing the SVG1501 wireless
gateway. For information on WLAN setup, see

Before You Begin

Before you begin the installation, check that the following items were included with your
Motorola SVG1501 Wireless Cable Modem Gateway:
Power cord
10/100Base-T Ethernet
Software License &
Regulatory Card
SVG1501 Installation
SVG1501 Install Sheet
You must have the latest service packs and patches installed on your computer for your
operating system. You will need a 75-ohm
connect the SVG1501 to the nearest cable outlet. If a TV is connected to the cable
outlet, you may need a 5 to 900 MHz RF splitter and two additional coaxial cables to use
the TV and the SVG1501.
2 • Getting Started
This document is uncontrolled pending incorporation in a Motorola CMS

Getting Started

Setting Up Your Wireless
Connects the SVG1501 to an AC electrical outlet
Connects the SVG1501 to the network via the
Ethernet port. Cable must be Cat 5 or greater.
Contains software license, warranty, and safety
information for the SVG1501.
Contains the SVG1501/SVG1501U Wi-Fi Wizard,
software license agreement, and multi-language
User Guides. USB drivers are also included for
SVG1501U model only.
Provides basic information for setting up the
coaxial cable
with F-type connectors to


Table of Contents

  Also See for Motorola SURFboard SVG1501 Series

  Related Manuals for Motorola SURFboard SVG1501 Series