I Receive Mode Selection; I Lock Function - Icom IC-R1500 Instruction Manual

I Receive mode selection

Receive modes are determined by the physical properties of
the radio signals. The receiver has 6 receive modes: SSB
LSB, CW, AM, WFM and FM modes. The mode selection is
stored independently in each memory channels.
Typically, AM mode is used for the AM broadcast stations
(0.495–1.620 MHz) and air band (118–135.995 MHz), and
WFM is used for FM broadcast stations (76–107.9 MHz).
When Automatic mode is selected, IF filter passband width,
tuning step, etc., are selected automatically after inputting a
frequency. (p. ??)
➥ Push [TS•MODE] for 1 sec. to enter the receive mode se-
lect mode.
[TS•MODE]
r Rotate [DIAL] to select the desired mode.
[DIAL]
tPush [TS•MODE] to exit the receive mode select mode.
SETTING A FREQUENCY

I Lock function

To prevent accidental frequency changes and unnecessary
function access, use the lock function.
➥ Push [SET•LOCK] for 1 sec. to turn the lock function ON
and OFF.
• [SET•LOCK] (lock function only), [MONI•T/T•SCAN] (monitor
function only), [PWR], [VOL] and [SQL] can be used while the
channel lock function is in use.
[SET•LOCK]
2
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
8