Advanced Security - TP-Link TL-WR841N User Manual

Chapter 5
• PPTP Passthrough
to-Point Protocol (PPP) to be tunneled through an IP network. If you want to allow
PPTP tunnels to pass through the router, you can keep the default (Enabled).
• L2TP Passthrough
to enable Point-to-Point sessions via the internet on the Layer 2 level. If you
want to allow L2TP tunnels to pass through the router, you can keep the default
(Enabled).
• IPSec Passthrough
ensuring private, secure communications over Internet Protocol (IP) networks,
through the use of cryptographic security services. If you want to allow IPSec
tunnels to pass through the router, you can keep the default (Enabled).
• ALG - It is recommended to enable Application Layer Gateway (ALG) because ALG
allows customized Network Address Translation (NAT) traversal filters to be plugged
into the gateway to support address and port translation for certain application layer
"control/data" protocols such as FTP, TFTP, H323 etc.
• FTP ALG - To allow FTP clients and servers to transfer data across NAT, keep
the default Enable.
• TFTP ALG - To allow TFTP clients and servers to transfer data across NAT, keep
the default Enable.
• H323 ALG - To allow Microsoft NetMeeting clients to communicate across NAT,
keep the default
• SIP ALG - To allow some multimedia clients to communicate across NAT, click
Enable.
• RTSP ALG - To allow some media player clients to communicate with some
streaming media servers across NAT, click Enable.
3. Click Save.
5. 8. 2.

Advanced Security

1. Visit http://tplinkwifi.net, and log in with the username and password you set for the
router.
2. Go to Security >
attacked by ICMP-Flood, UDP Flood and TCP-SYN Flood.
- Point-to-Point Tunneling Protocol (PPTP) allows the Point-
- Layer 2 Tunneling Protocol (L2TP) is the method used
- Internet Protocol Security (IPSec) is a suite of protocols for
Enable.
Advanced Security, and you can protect the router from being
Configure the Router in Hotspot Router Mode
98