Remote Management - TP-Link TL-WR841N User Manual

Chapter 4
For example, if you want to allow PCs with specific MAC addresses to access the router's
Web-based Utility locally from inside the network, please follow the instructions below:
1 ) Select Only the PCs listed can browse the built-in web pages to perform
Administrator
2 ) Enter the MAC address of each PC separately. The format of the MAC address
is XX-XX-XX-XX-XX-XX (X is any hexadecimal digit). Only the PCs with the listed
MAC addresses can use the password to browse the Web-based Utility to
perform administrator tasks.
3 ) Click Set, and your PC's MAC address will also be listed.
4 ) Click Save.
Note:
If your PC is blocked but you want to access the router again, press and hold the
factory defaults.
4. 8. 4.

Remote Management

1. Visit http://tplinkwifi.net, and log in with the username and password you set for the
router.
2. Go to Security >
remote device via the internet.
• Web Management Port
service port 80. This router's default remote management web port number is 80.
For higher security, you can change the remote management web port to a custom
port by entering a number between 1 and 65534 but do not use the number of any
common service port.
• Remote Management IP Address
your router via a remote device. This function is disabled when the IP address is set
to the default value of 0.0.0.0. To enable this function, change 0.0.0.0 to a valid IP
address. If it is set to 255.255.255.255, then all the remote devices can access the
router from the internet.
tasks.
Remote Management, and you can manage your router from a
- Web browser access normally uses the standard HTTP
- This is the address you will use when accessing
Configure the Router in Wireless Router Mode
Reset button to reset the router to the
46