Alarm Overview - Danfoss ECL Comfort 210 Operating Manual

Operating Guide ECL Comfort 210/296/310, application A232 / A332

5.11 Alarm overview

MENU > Alarm > Alarm overview
This menu shows the alarm types, for example:
• "2: Temp. monitor"
• "32: T sensor defect"
The alarm has been activated if the alarm symbol (a bell) is present
to the right of the alarm type.
116 | © Danfoss | 2017.08
Resetting an alarm, in general:
MENU > Alarm > Alarm overview:
Look for alarm symbol in specific line.
(Example: "2: Temp. monitor")
Move cursor to the line in question.
Push dial.
Alarm overview:
Alarm sources are listed in this overview menu.
Some examples:
"2: Temp. monitor"
"5: Pump 1"
"10: Digital S12"
"32: T sensor defect"
Related to the examples, the numbers 2, 5 and 10 are used in the alarm
communication to the BMS / SCADA system.
Related to the examples, "Temp. monitor", "Pump 1" and "Digital S12"
are the alarm points.
Related to the examples, "32: T sensor defect" indicates the monitoring
of connected sensors.
Alarm numbers and alarm points might differ depending on actual
application.
VI.JM.G2.02