Settings Overview - Danfoss ECL Comfort 210 Operating Manual

Operating Guide ECL Comfort 210/296/310, application A232 / A332

4.0 Settings overview

For factory settings and setting range, see appendix "Parameter ID overview".
Parameters indicated with an ID no. like "1x607" mean a universal parameter. x stands for circuit / parameter group.
Setting
Heat curve
Xp actual
Day
Start time
Duration
Desired T
Circuit, sensor (functionality of return / surface temperature
sensor)
Circuit, sensor (functionality of return / surface temperature
sensor)
ECA addr. (ECA address, choice of Remote Control Unit)
Auto saving (saving temp. dependent on outdoor temp.)
Boost
Optimizer (optimizing time constant)
Adapt. time (adaption time)
Based on (optimization based on room / outdoor temp.)
Total stop
P exercise (pump exercise)
M exercise (valve exercise)
Actuator
Pre-stop (optimized stop time)
Room T diff. (Room temperature difference for switching
cooling mode ON and OFF)
Limit (return temp. limitation)
High T out X1 (return temp. limitation, high limit, X-axis)
Low limit Y1 (return temp. limitation, low limit, Y-axis)
Low T out X2 (return temp. limitation, low limit, X-axis)
High limit Y2 (return temp. limitation, high limit, Y-axis)
Infl. - max. (return temp. limitation - max. influence)
Infl. - min. (return temp. limitation - min. influence)
Adapt. time (adaptation time)
Stop at T out (Stop function related to the outdoor
temperature)
P post-run
Limit (Limitation of surface temperature)
Adapt. time (adaptation time)
Infl. max (Influence during heating mode)
Infl. min (Influence during cooling mode)
P cool T (cooling demand)
Circ. P frost T
VI.JM.G2.02
ID Page
69
95
117
117
118
118
1x003 79
1x003 83
1x010 99
1x011 86
1x012 87
1x014 88
1x015 73
1x020 89
1x021 89
1x022 99
1x023 99
1x024 93
1x026 90
1x027 73
1x030 80
1x031 80
1x032 80
1x033 80
1x034 80
1x035 81
1x036 81
1x037 81
1x038 109
1x040 100
1x060 84
1x061 84
1x062 84
1x063 84
1x070 100
1x076 100
Factory settings in circuit(s)
1
© Danfoss | 2017.08 | 65
2