Holiday - Danfoss ECL Comfort 210 Operating Manual

Operating Guide ECL Comfort 210/296/310, application A232 / A332

6.3 Holiday

This section describes the function in general for the ECL Comfort
210 / 296 / 310 series. The shown displays are typical and not
application related. They might differ from the displays in your
application.
There is a holiday program for each circuit and a holiday program
for the common controller.
Each holiday program contains one or more schedules. Each
schedule can be set to a start date and an end date. The set period
starts on the start date at 00.00 and stops on the end date at 00.00.
Selectable modes are Comfort, Saving, Frost protection or Comfort
7-23 (before 7 and after 23, the mode is scheduled).
How to set your holiday schedule:
Action: Purpose:
Choose 'MENU'
Confirm
Choose the circuit selector at the top
right corner in the display
Confirm
Choose a circuit or 'Common controller
settings'
Heating
DHW
Common controller settings
Confirm
Go to 'Holiday'
Confirm
Choose a schedule
Confirm
Confirm choice of mode selector
Choose mode
. Comfort
∙ Comfort 7–23
. Saving
∙ Frost protection
Confirm
Enter the start time first and then the
end time
Confirm
Go to 'Menu'
Confirm
Choose 'Yes' or 'No' in 'Save' . Choose
the next schedule, if required
VI.JM.G2.02
The holiday program in the 'Common controller settings' is valid for
all circuits. The holiday program can also be set individually in the
heating or DHW circuits.
The end date must be at least be one day later than the start date.
Examples:
© Danfoss | 2017.08 | 121