Operating Guide
5.13 Alarm overview
MENU > Alarm > Alarm overview
This menu shows the alarm types, for example:
•
"2: Temp. monitor"
•
"32: T sensor defect"
The alarm has been activated if the alarm symbol (a bell) is present
to the right of the alarm type.
Danfoss District Energy
ECL Comfort 310, application A368
Resetting an alarm, in general:
MENU > Alarm > Alarm overview:
Look for alarm symbol in specific line.
(Example: "2: Temp. monitor")
Move cursor to the line in question.
Push dial.
Alarm overview:
Alarm sources are listed in this overview menu.
Some examples:
"2: Temp. monitor"
"5: Pump 1"
"10: Digital S12"
"32: T sensor defect"
Related to the examples, the numbers 2, 5 and 10 are used in the alarm
communication to the BMS / SCADA system.
Related to the examples, "Temp. monitor", "Pump 1" and "Digital S12"
are the alarm points.
Related to the examples, "32: T sensor defect" indicates the monitoring
of connected sensors.
Alarm numbers and alarm points might differ depending on actual
application.
VI.LG.J3.02
DEN-SMT/DK
117